Autocad files were good. Cut out fine on plasma table. Everything was good until I started putting it together. There was no instructions on the order of the pieces to be tacked together so it would fit correctly. The angles could have been nice to know also. Had to work my way backwards by putting the frame pieces on, ones with holes and triangular pieces, then put the big rectangular piece on for the bottom. The next step that I did was putting the vertical side pieces of the wings at 90’s in relation to the top wing piece. I put the those pieces on next making sure it was flat and looked nice. Next step was the bottom wing pieces which were easy because I just had to line them up. I also had to modify parts of the frame tie ins because they were interfering with parts of my Jeep. This bumper caused me a decent amount of confusion having to guess on the order of the piece installation with no angles. A little instruction book would have been nice to have, atleast a few pages. Overall it’s a nice bumper. Just wished it could have been easier to get together.
